« To Async recording: Overview
Use Riverside to record yourself at a convenient time and share the footage with whoever invited you. You can also use the teleprompter or share your screen while you record.
Watch a video
Step by step
Follow the steps below based on if you're using a computer or your mobile device.
-
Record async from a computer
Join the studio and set up mic and camera
- On a computer, open the invite link you received in a Chrome or Edge browser.
The invite URL looks like:https://riverside.fm/async-recording/invitation/bbee2ebli......62f
- On the Welcome to Riverside! screen, click Start setup.
- If you haven't used Riverside before, grant access to your camera and mic.
- In the pop-up below the address bar, click Allow for both camera and microphone.
- Under Check your mic and camera, choose your computer's built-in hardware, or select from other connected recording equipment.
- Speak into the mic and check that the audio meter reacts.
- Click Next.
- Bring the camera to your eye level and center yourself in the frame.
- Click Next.
Continue below.
Record short A/V test (optional)
- When you are ready to begin, click Record and start speaking.
- After 15-30 seconds, click Stop and review recording preview.
- Click Record again to delete the test recording and start over.
- Make any necessary adjustments to your camera angle or mic position.
Repeat the above steps to do another test if needed, then continue below.
Record yourself
- At the bottom of the screen, click Record and start speaking.
- When you are finished, click Stop.
- After the preview finishes generating, click the thumbnail to watch it (optional).
- Click Record again to erase the footage and start over (optional).
- Type in your name and email address.
This helps distinguish the files for the host and provides contact information to the host, if needed. - Click Send recording.
Keep the Riverside page open in your browser until the upload finishes and you see Your recording is sent.
- On a computer, open the invite link you received in a Chrome or Edge browser.
-
Record async from your phone
Join the studio and set up mic and camera
- Download and launch the Riverside iOS app or the Riverside Android app.
- Open the invite link you received.
The invite URL looks like:https://riverside.fm/async-recording/invitation/bbee2ebli......62f
- Under Let's get started, enable access to the prompted permissions.
- Click Continue.
- Once your'e ready, Click I'm ready.
Record yourself
- At the bottom of the screen, click Record and start speaking.
- When you’re finished, click Stop.
-
Click the video to preview it.
To erase the footage and start over, click Retake at the bottom of the screen. -
If you're satisfied with the result, click Continue.
-
Enter your name and email address to help distinguish the files for the host and provide contact information if needed.
Record yourself - landscape
- Tilt your phone to record in landscape mode.
- On the right side of the screen, click the
Record icon and start speaking.
- When you’re finished, click the
Stop icon.
-
Click the video to preview it.
To erase the footage and start over, click Retake at the top left corner. -
If you're satisfied with the result, click Continue.
-
Enter your name and email address to help distinguish the files for the host and provide contact information if needed.
Good to know
- You can record as many times as you want. However, only the last recording you make will be shared.
- Before you begin recording your entire segment, do a short recording to check your camera and mic setup, then review the test.
- Screen sharing is not available on mobile.